Computer embroidery machine gold piece embroidery

Update:11 May 2019
Summary:

Computer embroidery machine sequin embroidery wear piec […]

Computer embroidery machine sequin embroidery wear piece:

Insert the disc to be embroidered from the rear of the bottom plate into the gap between the stopper and the bottom plate and push it forward to the front of the tongue tip of the stopper, or use a key-shaped device. Puncture the stopper from the side of the stopper and slightly move it forward to raise the tip of the stopper slightly. At this time, the disc can be sent forward from the gap between the stopper and the bottom plate. After the disc is sent forward, the key-shaped device is slightly moved backwards, so that the tongue-shaped tip of the stopper is inserted into the hole of the sheet, and then the piece of the piece is taken out, and the hand on the sheet feeding motor can be rotated by hand. For the wheel, use the feeder to feed the discs one by one.

Adjustment of computer embroidery machine gold piece feeder limit device:

When embroidering 3 to 4 mm sequins, the feeder must be moved forward into position, and the distance between the feeder and the cutter must be 2 knots, that is, the tip of the feeder should be cut after being fed into place. In the third hole behind the knife. When embroidering a 5 to 7 mm sequin, the feeder is fed forward and the distance between the feeder and the cutter is one segment. That is, the tip of the feeder should be in place after being fed into place. In the second hole after cutting the knife.

After the disc is sent out to the outside of the cutter according to the above regulations, the cutter is used to block the disc by hand. If the blocked disc is not round, adjust the orientation of the feed limiter before and after, and cooperate with the rolling feed motor handwheel. Feed the film forward and observe the slice until the blocked disk is the ideal circular stop. After confirming the adjustment, tighten the fastening screw of the stopper.

Copyright © Zhejiang Lejia Electrical Machinery Co., Ltd. All Rights Reserved.

Web Support By :HWAQ