Adjust the optimal position of the computer embroidery machine shuttle

Update:11 Jun 2019
Summary:

Adjusting the computer embroidery machine shuttle bed i […]

Adjusting the computer embroidery machine shuttle bed is actually the best orientation for adjusting the cooperation between the upper shaft and the lower shaft. In principle, the bottom line can only be taken after forming the wire loop. In this process, three orientations are involved, Top dead center,The bottom dead center, Take the line position. That is to say, the needle bar runs to the uppermost point, and the bottom point and the bottom position of the computer embroidery machine shuttle bed. In these several directions, the most important thing is to take the line. Generally speaking, the adjustment of the computer embroidery machine shuttle bed is actually to adjust the line position. Before the adjustment, the upper and lower stop points must be adjusted. The needle must be upright.

The computer embroidery machine shuttle bed adjusts the line position process:

1. First turn the dial to the take-up line scale (different models are different)

2. Press the needle bar down, facing the machine head, and observe the half pinhole as the best orientation of the needle bar at a 45-degree angle.

3. Adjust the orientation of the computer embroidery machine shuttle bed and the tip of the needle. The needle tip is just facing the computer embroidery machine. The hook of the machine is taken from the hook. The locking screw moves to the left and right. The needle of the computer embroidery machine can cover the tip of the computer embroidery machine. Good orientation.

4. Adjust the distance between the computer embroidery machine shuttle and the needle tip (the distance is too wide to bring the bottom line).

Copyright © Zhejiang Lejia Electrical Machinery Co., Ltd. All Rights Reserved.

Web Support By :HWAQ